Decide
Four situations at sea. Decide first, then read why.
At the mooring station a line comes under heavy strain and an AB is standing in a bight of it. What do you do?
Key points
- Draught, freeboard, load lineDraught down to the keel, freeboard up to the deck line; never submerge your load line.
- Metric figures 10 cm high; bottom edge = the value.
- Lines: TF, F, T, S, W (and WNA).
- Limits are set as freeboards for each zone and season.
- G, B, M, GMGM is G to M: large is stiff, small is tender, slack tanks cut it.
- Displacement = lightship + deadweight.
- Weight high raises G and reduces GM.
- List from inside, heel from outside, trim fore and aft.
- Mooring safelyBreasts hold her in, springs stop her surging; the whole deck is a snap-back zone.
- Helmet, safety shoes, gloves; radio with the ship's name.
- Never stand in a bight or in line with a line under strain.
- Monkey's fist rope only; shout "Stop!" at danger.
- AnchoringOne shackle is 27.5 m; brought up means holding, dragging means moving.
- Windlass heaves and lets out anchor and cable.
- Report shackles out and the cable's lead by the clock.
- Anchor watch: position, lookout, report.
Check what you have read
What is the freeboard?
Worked case: Making fast aft with the second officer
Your ship is coming alongside, port side to. You are the cadet at the aft mooring station with the second officer, the bosun and two ABs. The plan is two stern lines and two springs aft. The second officer has the radio to the bridge.
Before you read the solution: what would you do?
True or false?
Decide each statement before you see the answer.
Once the anchor is down, the ship is safe and nobody needs to watch.
If I stand outside the painted snap-back zone I am safe.
A bigger GM is always safer.
One shackle is 27.5 m; brought up means holding, dragging means moving.
A heavier monkey's fist throws further, so add a shackle.
Draught down to the keel, freeboard up to the deck line; never submerge your load line.
GM is G to M: large is stiff, small is tender, slack tanks cut it.
Draught is the depth of water under the ship.
List and heel are the same thing.
Breasts hold her in, springs stop her surging; the whole deck is a snap-back zone.
Exercise: Read the marks, name the line
A cargo ship with metric draught marks. Decide, then read the worked solution.
Step by step
The waterline is at the bottom edge of the figure 4 just above the 7M mark. What is the draught, in metres?
Which mooring lines provide most of the fore-and-aft (longitudinal) restraint?
A ship rolls slowly and lazily, taking a long time to come back upright. What does this suggest?
How many metres are in one shackle of cable?
Now on your own
Now without help. Checked at the end.
Forward draught 6.2 m, aft draught 7.0 m. What is the trim, in metres (by the stern)?
Which change raises G and reduces the ship's GM?
Put the aft mooring station's steps in order.
- 1Throw the heaving line beyond the linesman
- 2Report the line ashore and on the bollard
- 3Heave in, then stopper off and make fast on the bitts
- 4Check PPE, the plan and the radio link
At anchor, the bearings of two shore marks keep changing and the cable shudders. What is happening?
Check: 10 questions
Questions from this subject, explained after each answer.
Free: lesson + 10 questions · Exam Pass: all 27 questions, unlimited practice tests, your mistakes retrained
The full explanation and the lessons for each programme item
Topic 1 of 6
Draught, freeboard and the load line mark
The draught is the depth of the hull below the waterline: from the waterline down to the bottom of the keel.
The freeboard is the height of the ship's side above the waterline, measured amidships from the waterline up to the deck line. Load more cargo and the draught grows while the freeboard shrinks.
Draught marks are painted on both sides, forward and aft and usually amidships. In metric marks each figure is 10 cm high and the figures are 10 cm apart: when the waterline touches the bottom edge of a figure, the draught is that figure; when it touches the top edge, add 10 cm. Read them at eye level and average out the waves.
The load line mark sits amidships on both sides: a deck line, a ring with a horizontal line through it, and a ladder of short lines for different zones, seasons and water: tropical fresh (TF), fresh (F), tropical (T), summer (S) and winter (W), plus winter North Atlantic (WNA) on smaller ships. The ship may not be loaded deeper than the line for the zone and season she is in.
IMO explains why: limiting how deep a ship may load contributes greatly to her safety. The limits are set as freeboards, they allow for the hazards of different zones and seasons, and the idea goes back to keeping enough reserve buoyancy. Fresh water lines sit higher because a ship floats deeper in less dense fresh water and rises again at sea.
- Draught: waterline down to the keel. Freeboard: waterline up to the deck line.
- Metric draught marks: figures 10 cm high, bottom edge = the figure.
- Load line: never submerge the line for your zone and season.
Topic 2 of 6
Weight, G, B, M and GM in plain words
A floating ship displaces its own weight of water, so displacement is the ship's total weight.
Lightship is the empty ship. Deadweight is everything she carries on top: cargo, fuel, ballast, fresh water, stores and crew. Displacement = lightship + deadweight.
G, the centre of gravity, is where the ship's whole weight acts down. B, the centre of buoyancy, is the centre of the underwater volume, where buoyancy pushes up. When the ship heels, B moves to the low side. M, the metacentre, is the point the buoyancy force passes through for small angles of heel. GM, the metacentric height, is the distance from G up to M.
With G below M (positive GM) the ship comes back upright. A large GM makes her stiff: a quick, jerky roll that is hard on cargo lashings and people. A small GM makes her tender: a slow, lazy roll, with less margin. Weight loaded high raises G and reduces GM; weight loaded low lowers G and increases it.
Free surface effect: in a slack (partly filled) tank the liquid runs to the low side as the ship heels, which acts like raising G and reduces the effective GM. That is why tanks are kept full (pressed up) or empty where possible.
- Positive GM: she comes back. Large GM: stiff. Small GM: tender.
- List: a lean caused by weight inside the ship (off-centre load, a slack tank). Heel: a lean caused by outside forces such as wind, waves or a turn. Trim: the difference between the draughts forward and aft.
- Deeper aft is trim by the stern; deeper forward is trim by the head.
Topic 3 of 6
Mooring lines and the mooring station
Head lines lead ahead from the bow and stern lines lead astern from the stern.
Breast lines run roughly at right angles to the ship and hold her alongside: the MCA Code says they give most of the athwartships restraint. Springs lead forward or aft along the ship (the forward spring from forward leading aft, the aft spring from aft leading forward) and give most of the fore-and-aft restraint.
Each mooring party has a responsible person in charge, usually an officer, with a clear view of all the lines and people, and a radio link to the bridge. On radio, say the ship's name and your station so nobody on the same channel is confused. Everyone wears a safety helmet, safety shoes and gloves and is briefed on the berthing plan. People who are not in the mooring party keep off the mooring deck.
Snap-back: a line under tension that parts, or a snagged line that suddenly frees, can whip back across the deck with lethal force, sideways or up and down. The MCA Code says to treat the whole mooring deck as a danger area, and advises against painting snap-back zones on deck because they can give a false sense of security. Use the bird's-eye plan from the briefing, stay out of the line of any line under strain, and never stand in a bight.
A bight is a loop of rope. If the line tightens while you stand in it, it takes you with it. Keep your hands clear of the drum end, the fairlead and the bollard as the line runs.
- Breasts hold her in; springs stop her moving fore and aft.
- The whole mooring deck is a danger zone when lines are under strain.
- Never stand in a bight; never stand in line with a line under tension.
Topic 4 of 6
Handling lines safely
The heaving line is the light line thrown ashore first, with the mooring line bent on to it. Its monkey's fist is made of rope only: the MCA Code forbids weighting it with shackles, bolts or nuts.
Shout a warning before you throw, and throw beyond the linesman, never at them.
On the drum end, one person tends the turns and a second stands at least a metre back, taking up and coiling the slack; three turns are usually enough. Never surge a synthetic rope on the drum end. Once the line is tight, put on a stopper (rope stopper on rope, chain on wire), take the line off the drum and make it fast on the bollard or bitts in figures of eight.
If any part of the system looks overloaded, act at once to take the load off, and say so on the radio. Anyone who sees danger, a person in a bight or a line about to jam, shouts "Stop!" and the winch stops.
- Monkey's fist: rope only, never weighted.
- Rope stopper on rope, chain stopper on wire.
- See danger: shout "Stop!"
Topic 5 of 6
Anchoring terms
The windlass heaves in and lets out the anchor and its cable (the anchor chain).
The cable is measured in shackles: the MCA Code gives three shackles as 82.5 metres, so one shackle of cable is 27.5 metres. The forward party reports how many shackles are out and how the cable is leading, by the clock face: "Three shackles in the water, cable leading two o'clock."
Before letting go, a competent seafarer checks the brake is on and clears the securing devices; the anchor is usually walked out clear of the hawse pipe first. The anchor party wears a helmet, safety shoes, gloves and goggles against rust and debris thrown off the cable, and stands aft of or well clear of the windlass.
The ship is brought up when the anchor holds and she rides to her cable: the cable comes taut and then slackens as she settles back. She is dragging when the anchor is not holding: her position or bearings change, she moves outside her swinging circle, or the cable jerks and shudders. On anchor watch you check the position regularly, keep a lookout and report any change at once.
- One shackle of cable: 27.5 m.
- Brought up: holding. Dragging: moving.
- Anchor watch: position, lookout, report.
Topic 6 of 6
Practise and go further
The best places to practise this subject. When you finish, one tap brings you back to the course.
All lessons by programme item
- 7.1 Draught, freeboard, draught marks and the load line mark
- 7.2 Displacement, deadweight, G, B, M and GM; stiff and tender; list, trim and heel; free surface effect
- 7.3 Mooring: lines, stations, snap-back, bights, commands and safe line handling
- 7.4 Anchoring terms: windlass, cable, shackles, brought up, dragging and anchor watch
Sources
Checked against the sources on .
